Dieffenbachia hammelii occurs in southeastern Nicaragua (Dpto. Rıo San Juan) and northern Costa Rica from sea level to 100 m in the Tropical wet forest life zone, in wet forests and swampy areas on the Atlantic slope.
Dieffenbachia hammelii is a species of genus Dieffenbachia. This species was described by Thomas Bernard Croat & Michael Howard Grayum in 1999.
IDENTIFY DIEFFENBACHIA HAMMELII
Dieffenbachia hammelii occurs in southeastern Nicaragua (Dpto. Rıo San Juan) and northern Costa Rica from sea level to 100 m in the Tropical wet forest life zone, in wet forests and swampy areas on the Atlantic slope.
It is a herbaceous perennial grows 25-40 cm tall. The leaves are narrowly to broadly elliptic or oblanceolate, 9-28 x 3.2-13 cm, upper surface medium to dark green, weakly glossy to semi-glossy; lower surface weakly glossy to matte, slightly to moderately paler.
The species is characterized by its small stature, typically 25-40 cm; its glossy, decumbent, sub-rhizomatous stems; weakly sheathed, matte-drying petioles (sheath decurrent at apex); and moderately small, more or less oblong-elliptic, weakly inequilaterally green leaf blades with moderately numerous primary lateral veins. One blade margin is usually plane and one margin usually minutely undulate.
This species blooms from March through May and also July, while mature fruits have been seen in August and September. Cultivated plants at the Missouri Botanical Garden flowered in mid July and mid October.
DIEFFENBACHIA HAMMELII CARE AND CULTURE
Cultural information should only be used as a guide, and should be to be adapted to suit you. Your physical location; where you grow your plants, how much time you have to devote to their care, and many other factors, will need to be taken into account. Only then can you decide on the cultural methods that best suit you and your plants.
Light:
Dieffenbachia hammelii tolerates a wide range of light conditions. Preferred levels of 1000 to 2000 foot candles. They will grow in heavy shade and can be used in dark areas of the home, but growth will be slowed. Best growth is achieved in bright indirect light.
Insufficient light can cause the lower leaves fall off and plant becomes leggy. Leaf yellowing or discoloration caused by plant being in full sunlight.
Rotate the plant regularly to provide adequate light to all sides of the plant and prevent it from reaching toward the light on one side.
Temperature:
Best growth occurs between 65° and 75°F. The temperature should not drop below 50°F. The lower leaf drop because of sudden changes in temperature, or the plant is in a drafty location.
Humidity:
A relatively moist atmosphere results in vigorous growth, because its large leaves may dry up in a hot room. Maintain humidity by grouping plants or with a pebble tray.
Low humidity in the room can cause the leaves dry up. Position the plant away from radiators, group plants, use pebble trays
Substrate and growing media:
Dieffenbachia hammelii needs a loose, fertile, high organic medium. Many different mixes can be used. The plants can be grown in pure peat; peat and perlite (1:1), soil and peat (1:1); or soil, peat and perlite/vermiculite (1:1:1). The growing medium should have good water-holding capacity and be well drained.
Repotting:
For smaller desktop plants, repotting once every 12-18 months with a potting vessel 1”- 2” larger in diameter to allow for growth. For larger floor plants, repotting every 18-24 months with a potting vessel 2”- 4” larger in diameter to allow for growth.
Don’t choose a pot much larger than the previous as this could drown the plant's roots. If you prefer to maintain the current size of your plant, repot into the same vessel, providing new soil and trimming away some roots and foliage. Spring or summer is the ideal time to repot as the plant is at its strongest.
Watering:
Maintain moderately moist soil. Watering is an important part of growing this plant. Water thoroughly and then not again until the surface of the potting medium is dry to the touch. Plants can be rooted and grown in water. Plants grown in soil should not be water logged; the plant will not tolerate constant overwatering. Overwatering cause yellowing and dropping off of lower leaves, plant rots off at the base.
Fertilizer:
The plant given a minimal amount of nutrients will grow slowly and retain a desired shape. If the plants are growing in limited light, they require less frequent fertilization. As a general guide, you can use a complete fertilizer such as 20-20-20 and feed every 4-6 weeks only during the active growing season.
Brown leaf edges and/or leaf tips, tip burn because of too much fertilizer or too dry for short periods. If there are excessive fertilizer salts in the soil, these salts will be in solution in this water droplet. When the droplets evaporate, the salts remain on the tip of the leaf and cause tip burn.
Pests and diseases:
Bacterial Rot/ Blight - a bacterial pathogen that causes soft rot. Ants can cause considerable damage because they carry certain aphids, which in turn secrete a honeydew. The ants gather and feed on this honeydew. Fungus may develop.
Mealybugs: The nymphs of this pest feed on the sap of the plant by piercing the outer layer of plant tissue and secrete the honeydew that is attractive to ants. Mealybugs can be controlled by wiping the area with a cotton ball dipped in rubbing alcohol.
Propagation:
New plants can be made from stem cuttings. Use tip cuttings from the terminal portion of the plant or from small shoots that develop from lateral buds. Be sure to avoid contact of the plant juice with skin.
Stems that have become bare from dropped leaves can be cut into 2” pieces (with at least one lateral bud). Dry the cuttings for a day, then stick them in a rooting medium such as peat, sand, perlite or vermiculite. Stem cuttings establish roots faster in sphagnum moss than in sand, and cuttings from the top of the plant root faster than sections taken from the base of the stem.
Larger stems initiate roots faster than smaller stems, apparently because the larger stems contain more stored food. Air layering can be used when the plant becomes top-heavy or lanky with naked stems.
COMMENTS